Filter
Top Products
Activating the i
compartment
This function should be activated if
traditional "big box" detergents are
used. For the first 10 seconds of the
Cottons main wash cycle water flows
in through compartment i.
Compartment j may sometimes not
be able to hold the total amount of de
-
tergent required when:
- the water is very hard (over 3.8
mmol/l, water hardness level IV) and
- the washing is heavily soiled.
In this case compartment i can be
used to flush in the extra detergent for
the main wash.
Before the "Activating the i compart-
ment" programmable function can be
selected you must first select program-
ming mode.
Selecting programming mode
AThe machine must be switched off
and the drum door closed. The
programme selector must point to
Finish
.
BPress the additional option buttons
Short
and
Water plus
at the same
time and hold pressed in and:
C. . . switch the machine on with the
I-ON/0-OFF-button.
DLet go of all these buttons.
The indicator light
Main wash
flashes in
the sequence display.
Selecting the programmable function
To select the "Activating the i com
-
partment" programmable function turn
the programme selector to - Spin ***.
Activating
To activate "Activating the i compart
-
ment" press the START button once.
The
Rinses
light comes on in the se
-
quence display.
Storing in memory
To store the "Activating the i compart
-
ment" programmable function in the
memory SWITCH the machine OFF with
the I-ON/0-OFF button.
The "Activating the i compartment"
programmable function is now stored in
the machine’s memory.
Deactivating
To deactivate the use of Compartment
i repeat the procedure given above
from point A as far as the *** shown
above. Press the START button and the
Rinses
indicator light will go out. The
function is deactivated. Store in mem
-
ory by pressing the I-ON/0-OFF button.
Programmable functions
34