Miele w864 Washer User Manual


 
Before using the machine for the first
time ensure that it is correctly in
-
stalled and connected. See the rele
-
vant section under "Installation".
Also check that the fluff filter is se
-
curely tightened. Otherwise there is
a risk of water leakage during use.
Flushing out the machine
Any residual lubricants and water from
testing still in the machine should be
flushed out as follows:
^
Turn on the stopcock.
^ Do not load any laundry.
^ Add detergent to compartment j,
however
only add max.
1
/
4
of the
amount recommended on the pack-
aging for a full load.
^ Press the I-ON/0-OFF button in.
^ Turn the programme selector to COT-
TONS 60°C.
Important!
This programme must be selected in or
-
der to prepare the machine for spinning
and to activate the ball valve.
^
Press the
Water plus
button in. The
indicator light next to it will come on.
^
Press the "Spin" button repeatedly un
-
til the
Without final spin
indicator light
comes on.
^
Press the START button.
^
When this programme has finished
your washing machine is ready for
using for the first time.
Water hardness reminder dial
Several factors including the water
hardness level in your area will affect
how much detergent you should use.
The small dial in the detergent dis
-
penser drawer can be set purely as a
reminder of the hardness level.
^ Remove the yellow spatula from in-
side the dispenser drawer.
^
Adjust the dial to the appropriate set
-
ting (1 = soft, 4 = very hard).
Before using for the first time
12