Miele w864 Washer User Manual


 
Top-up rinse for Cottons
At the end of the main wash addi
-
tional water flows into the drum to
cool the suds down.
Hot suds can damage plastic drainage
pipes.
Top-up rinse takes place when temper
-
atures of 95°C and 75°C are selected.
Top-up rinse should be activated:
to prevent the danger of scalding if
the drain hose is hooked over the
edge of a sink or basin.
where the drainage pipes do not
comply with DIN 1986.
The washing machine is delivered with
the "Top-up rinse for Cottons" deacti-
vated.
Before the "Top-up rinse for Cottons"
programmable function can be se-
lected you must first select program-
ming mode.
Selecting programming mode
AThe machine must be switched off
and the drum door closed. The
programme selector must point to
Finish
.
BPress the additional option buttons
Short
and
Water plus
at the same
time and hold pressed in and:
C. . . switch the machine on with the
I-ON/0-OFF-button.
DLet go of all these buttons.
The indicator light
Main wash
flashes in
the sequence display.
Selecting the programmable function
To select the "Top-up rinse for Cottons"
programmable function turn the
programme selector to -
DELICATES cold ***.
Activating
To activate "Top-up rinse for Cottons"
press the START button once.
The
Rinses
light comes on in the se
-
quence display.
Storing in memory
To store the "Top-up rinse for Cottons"
programmable function in the memory
SWITCH the machine OFF with the
I-ON/0-OFF button.
The "Top-up rinse for Cottons" program-
mable function is now stored in the ma-
chine’s memory.
Deactivating
If the "Top-up rinse for Cottons" pro-
grammable function is no longer re
-
quired it can be deactivated. To do so
repeat the procedure given above from
point A as far as the *** shown above.
Press the START button and the
Rinses
indicator light will go out. The function
is now deactivated. Store in memory by
pressing the I-ON/0-OFF button.
Programmable functions
37