Filter
Top Products
Fault messages in the display
Problem Possible cause Remedy A
q
DRAIN
FAULT
–
The water outlet is
blocked or restricted.
–
The drain hose has
been fixed too high.
–
Clean the drain filter and
the drain pump.
–
The maximum drain height
is 1 m.
p
INLET
FAULT
–
The water inlet is
blocked or restricted.
Check whether
–
the stopcock is opened
wide enough.
–
the inlet hose is kinked.
o
WPS
ACTIVATED
The water protection
system has reacted.
Call the Service Department.
ä
DRUM LIGHTING
FAULT
The drum lighting is not
locked in position.
Check that the drum lighting
is sitting correctly.
,
TECHNICAL
FAULT
call Service Dept
There is a fault. Start the programme again.
If the fault message appears
again, contact the Service
Department.
The following will flash
in the display:
ANTI-CREASE
alternately with
CHECK DETERGENT
Excessive foam has built
up during washing.
Use less detergent next time
and follow the
manufacturer's instructions
on dosage given on the
packaging.
A To switch off the fault message: Switch the washing machine off with
I-On/0-Off
button.
Problem solving guide
39