Filter
Top Products
Change function of Filter/Vent
indication
Lint should be removed after drying.
At the same time, the Filter/Vent
indicator light reminds you to do so
as soon as a certain degree of lint
has accumulated. You can yourself
decide which degree of lint
accumulation will trigger that
reminder.
Determine by trial and error which of
the four options responds to your
drying practices.
For programming and saving in
memory, follow steps A to E.
The programmable function is
programmed using the buttons.
Precondition:
– The dryer is switched off.
– The door is closed.
A Press Start/Stop and keep it pressed
it during steps B-C.
B Press the I-On/0-Off button in.
Wait until the Start/Stop button lights up
continuously ...
C . . . then release the Start/Stop
button.
D Press the Gentle button four times.
–
The Gentle indicator light flashes
once slowly.
–
P and 2 flash alternatingly in the
display (default setting).
The number appearing alternatingly
with P means:
0 The Filter/Vent indicator is
deactivated
I The Filter/Vent indicator comes on
only when there is a heavy lint
buildup
(Express control light additionally
flashes once)
2 default setting
(the Express indicator light also
flashes twice)
3 The Filter/Vent indicator will come
on when there is only a light lint
buildup
(The Express indicator light also
flashes three times)
E Pressing the Start/Stop button
switches from one to the other.
F Using the I-On/0-Off button, switch
the dryer off.
The programming is now stored in
memory. You can change it again at
any time.
Programmable functions
50