Filter
Top Products
For right hand hinging only:
–
front panel shown decor side face
down, upper edge at the bottom:
if width (b) increases, measurement a
must also be increased
b = 592 mm N a =21.5mm
b = 593 mm N a = 22.0 mm
b = 594 mm N a = 22.5 mm
b = 595 mm N a = 23.0 mm
b = 596 mm N a = 23.5 mm
H = height of adjacent furniture unit
doors.
CDrill the two hinge holes (C 35
mm/15.5 mm deep) in the back of the
front panel.
DNext, drill the four smaller holes
(C 7 mm/10 mm deep) in the back of
the front panel.
EShorten the front panel from the
bottom to height H.
Preparing the fixing points
FHold the pre-drilled front panel in the
correct position in front of the
machine door.
GMark the fixing points on the back of
the front panel through the holes in
the machine door plate (see arrows
in the illustration).
HRemove the front panel.
INow drill holes (C 2.5 mm/10 mm
deep) in the back of the front panel.
Installation
46