Filter
Top Products
Fitting a door front panel made
by another manufacturer
Preparing the front panel
AMeasure distance X for drilling the
hinge holes.
–
with spacer bars:
– without spacer bars:
(the front panel must be
correspondingly higher)
BMark the two hinge holes and the
four smaller holes as shown in the
diagram.
For left hand hinging only:
–
front panel shown decor side face
down, upper edge at the bottom:
if width (b) increases, measurement a
must also be increased
b = 592 mm N a =21.5mm
b = 593 mm N a = 22.0 mm
b = 594 mm N a = 22.5 mm
b = 595 mm N a = 23.0 mm
b = 596 mm N a = 23.5 mm
H = height of adjacent furniture unit
doors.
Installation
45