Filter
Top Products
Anti-crease
If laundry is not removed as soon as
the programme has finished, the
drum will continue to rotate at
intervals for one hour to prevent
creasing.
The anti-crease function
–
is activated when the tumble dryer is
delivered. You can deactivate it if
wished.
–
is present on all programmes except
Woollens handcare.
– should be left activated, if laundry is
not normally removed immediately
after the end of a programme.
Follow steps A to G to programme
and store in memory.
Before you begin, first ensure that:
– The tumble dryer is switched off.
–
The door is closed.
–
The programme selector is at Finish.
APress the Start button and keep it
pressed in whilst carrying out steps
B-C.
BSwitch the dryer on with the
I-On/0-Off button.
CWait until the Start indicator lamp
lights up constantly . . .
D. . . and then release the Start button.
ETurn the programme selector to the
Minimum iron Low temperature
position.
FPressing the Start button switches
between activating and deactivating
this setting.
–
If the Drying indicator lamp is not
flashing:
Anti-crease is deactivated
–
If the Drying indicator lamp is
flashing:
Anti-crease is activated
(Factory default setting)
Whilst doing this the Cool air indicator
lamp will flash on and off, alternating
with 1 long and 1 short flash.
GSwitch the appliance off with the
I-On/0-Off button.
The setting you have selected is now
stored in memory. You can change it
again at any time.
To check:
^ Make sure the dryer is switched off,
the door is closed and the
programme selector is at Finish and
then carry out steps A to E.
The Drying indicator lamp will show you
which setting has been programmed.
^
Switch the dryer off.
The check is complete.
Programmable functions
44