Filter
Top Products
Extending the cooling down
time
The cooling down phase which takes
place before the end of a programme
can be lengthened if required. This
makes the garments easier to handle.
The dryer is delivered with the extended
cooling down time option deactivated.
You can extend the cooling down time
by 5 minutes or 10 minutes.
The option of extending the cooling
down time is available with the Cottons,
Minimum iron and Automatic
programmes.
Follow steps A to G to programme
and store in memory.
Before you begin, first ensure that:
– The tumble dryer is switched off.
– The door is closed.
–
The programme selector is at Finish.
APress the Start button and keep it
pressed in whilst carrying out steps
B-C.
BSwitch the dryer on with the
I-On/0-Off button.
CWait until the Start indicator lamp
lights up constantly . . .
D. . . and then release the Start button.
ETurn the programme selector to the
Cottons Machine iron position.
FPressing the Start button alters the
cooling down time.
–
If the Drying indicator lamp flashes
once:
The cooling down time will be five
minutes longer.
–
If the Drying indicator lamp flashes
twice:
The cooling down time will be ten
minutes longer.
–
If the Drying indicator lamp is not
flashing:
The cooling down time is not
extended.
Whilst doing this, the Cool air indicator
lamp will flash five times.
GSwitch the appliance off with the
I-On/0-Off button.
The setting you have selected is now
stored in memory. You can change it
again at any time.
To check:
^
Make sure the dryer is switched off,
the door is closed and the
programme selector is at Finish and
then carry out steps A to E.
The Drying indicator lamp will show you
if the cooling down time has been
extended.
^
Switch off the dryer.
The check is complete.
Programmable functions
43