Filter
Top Products
Activating and deactivating the
buzzer
A buzzer sounds (at intervals for a
maximum of 1 hr) to let you know the
programme has finished.
The tumble dryer is delivered with the
buzzer activated but you can deactivate
it if wished.
The buzzer will still sound if there is a
fault, even if it has been deactivated.
Follow steps A to G to programme
and store in memory.
Before you begin, first ensure that:
– The tumble dryer is switched off.
– The door is closed.
– The programme selector is at Finish.
APress the Start button and keep it
pressed in whilst carrying out steps
B-C.
BSwitch the dryer on with the
I-On/0-Off button.
CWait until the Start indicator lamp
lights up constantly . . .
D. . . and then release the Start button.
ETurn the programme selector to the
Cottons Hand iron position.
FPressing the Start button switches
between activating and deactivating
the buzzer.
–
If the Drying indicator lamp is not
flashing:
the buzzer is deactivated
–
If the Drying indicator lamp is
flashing:
the buzzer is activated
Whilst doing this, the Cool air indicator
lamp will flash four times.
GSwitch the appliance off with the
I-On/0-Off button.
The setting you have selected is now
stored in memory. You can change it
again at any time.
To check:
^ Make sure the dryer is switched off,
the door is closed and the
programme selector is at Finish and
then carry out steps A to E.
The Drying indicator lamp will show you
if the buzzer is activated.
^
Switch off the dryer.
The check is complete.
Programmable functions
42