Filter
Top Products
Altering the residual moisture
level in the Minimum iron
programme
The tumble dryer is designed to dry
effectively using as little energy as
possible.
However, if you require the laundry to
be drier or damper, you can reduce
or increase the default residual
moisture in the Minimum iron
programme.
Follow the steps (A,B,C ...) to
programme and store in memory.
Before you begin, ensure that:
– The tumble dryer is switched off.
– The door is closed.
– The programme selector is at Finish.
APress the Start button and keep it
pressed in whilst carrying out steps
B-C.
BSwitch the dryer on.
CWait until the Start indicator lamp
lights up constantly...
D. . . and then release the Start button.
ETurn the programme selector to
Cottons Normal+.
The Cool air lamp will flash twice.
The flashing sequence of the
Drying lamp shows which option is
currently selected.
–
If the Drying lamp is not flashing:
the residual moisture level will be
increased and laundry will be
damper.
–
If the Drying lamp flashes once: the
residual moisture level will remain
on the standard setting (factory
default setting).
– If the Drying lamp flashes twice:
the residual moisture level will be
reduced and laundry will be drier.
FPressing the Start button switches
between the 3 options.
GSwitch the dryer off.
The setting you have selected is now
stored in memory. You can change it
again at any time.
To check the setting:
^
Carry out steps A to E.
^
Switch the dryer off after checking
the setting as described above.
Programmable functions
43