Filter
Top Products
Problem Possible cause Remedy
:
Clean the plinth
filter which is
located in front of
the heat-exhanger
appears at the
end of a
programme.
This is a reminder to
clean the fine filter in
front of the heat
exchanger unit under
running water.
–
Clean the fine filter. See
"Cleaning and care".
To delete the message:
–
Touch the OK sensor.
;
Fit plinth filter
Fit the plinth filter
appears and the
programme
cannot be
started.
The fine filter is
missing or has been
replaced the wrong
way round.
–
Replace the fine filter
correctly.
–
See "Cleaning and care".
–
Switch the dryer off and then
on again.
Removing the fine
filter during a drying
cycle will cause the
programme to be
cancelled.
;
Technical fault
F1
A programme cannot
be started while there
is a fault message in
the display.
– Make a note of what is shown
in the display.
– Switch the dryer off and then
on again.
– If a programme still cannot
be started, Call Miele Ser-
vice.
Comfort cooling
The programme has
finished but the
laundry is still being
cooled down.
–
You can either unload the
drum and leave the laundry
to cool at room temperature
or leave it in the dryer to
continue cooling.
Problem solving guide
47