Filter
Top Products
Before the end of a programme
There is a cooling down phase at the
end of the drying sequence:
7 (=
Cooling down) appears in the display.
The programme is not finished until the
cooling down phase has been
completed.
End of the programme - unload the
drum
O Anti-crease and Finish will appear in
the display to indicate that the
programme has finished. The buzzer
will sound at intervals.
The dryer has an energy saving mode:
After the programme has finished, the
display will go out and the Start sensor
will flash slowly (see also "Settings
menu - Display / Keypad illumination".
During the Anti-crease phase, the drum
will rotate at intervals to prevent laundry
creasing. This is quite normal.
^ Press the a button to open the
door.
^
Remove the laundry.
Check that all items have been
removed from the drum. If items are
left in the dryer, they could be
damaged by overdrying when the
dryer is next used.
The dryer will switch off automatically
15 minutes after the end of a
programme / the end of the anti-crease
phase.
(If the dryer is signed on to the
Miele|home system, it will not switch
off automatically).
^
Press the s button to switch the
dryer off.
The buzzer will sound.
^
Close the door.
^
Empty the condensed water
container unless the dryer has been
connected for external drainage, in
which case it does not have to be
emptied.
Drum lighting
To give a good view of the inside of the
drum so that no items are overlooked:
The lighting comes on when the door is
opened if the dryer is switched on. It
will go out after a short while if the door
is left open and after the door is closed
to save energy.
4. End of the programme - unload the drum
30