Filter
Top Products
Problem Possible cause Remedy
Water leaks from the
dryer after the
condenser unit has
been cleaned.
–
The inner cover of
the condenser unit
has not been locked
properly and/or the
condenser unit has
not been positioned
correctly.
–
Fluff has collected in
the condenser unit
housing.
–
Ensure that the condenser
unit is positioned correctly
and lock the inner cover.
–
Check the rubber seals.
–
Use a cloth to remove any
visible fluff from the inside
of the condenser unit
housing.
The display and the
sensors are not lit up
and the Start sensor is
flashing slowly.
Standby. To save
energy the display and
sensor illumination
switches off
automatically.
–
Touch the Start sensor. The
display and sensors will
light up.
– See "Settings".
The programme does
not start.
No obvious cause. – Is the dryer switched on?
– Is the plug correctly
inserted into the socket and
switched on?
– Is the door closed
properly?
– Has the fuse or circuit
breaker tripped?
The display is in a
different language.
A different language
has been selected.
Set the language you want.
The flag symbol J will guide
you.
The interior drum
lighting does not
come on.
The lighting switches
off automatically (to
save energy).
–
Switch the dryer off and
then on again.
–
If the lamp needs to be
replaced, follow the
instructions in "Changing
the lamp" at the end of this
section.
The lock has been
activated.
–
Enter the code to
deactivate it and the light
will come on.
Problem solving guide
50