Filter
Top Products
Starting a programme
^
Touch the green illuminated Start sensor.
In order to start the programme you must place your finger
in the centre of the Start sensor when touching it.
If the programme does not start: wait for 4 seconds and
touch the Start sensor in the middle again.
G
Cottons 10:21
[
Normal - Extras (See :)
Time left: 1:19 h
Change !
– The time remaining counts down in the display.
– Symbols in the display show which section of the
programme has been reached.
Time left
The following factors all affect the estimated time remaining:
the residual moisture after spinning; the type of textile; the
load; the ambient room temperature; fluctuations in the power
supply or a programme interruption.
The time left during drying is continually monitored and
altered. This is why the time shown in the display may
fluctuate duration the programme. This is quite normal.
Programmes can also finish earlier than expected, if, for
example, particularly fine fabrics are being dried, the load is
very small or items were partially dry beforehand.
Some changes can be made after starting a programme:
Selecting a different programme
You cannot change to another programme once a
programme has started (this prevents unintentional
alterations).
You will need to cancel the current programme before you
can select a new one.
3. Start the programme
28