Filter
Top Products
^
Then flush the unit through from the
front.
^ Check the condenser unit again for
any visible fluff and if necessary flush
it through again until it has all gone.
^ Repeat as required.
^ Also make sure the rubber seals are
clean.
The rubber seals must not be
removed and must be free of kinks.
^
Shake the water off the condenser
unit until no more droplets of water
are visible.
Checking and cleaning the
condenser unit housing
^
Remove any soiling still visible inside
the housing unit by hand using a
damp cloth. Do not try and access
areas you cannot reach by hand!
Replacing the condenser unit
^
With the handle facing upwards,
push the condenser unit back into
position in its housing.
^
Turn the lever down to the horizontal
position, making sure that the hook
on the lever clicks into the groove.
When replacing the inner cover after
cleaning, ensure that the rubber seal
fits correctly into the groove.
^
Replace the inner cover making sure
the hooks locate correctly. Hold it at
an angle and push it gently
downwards.
^ Then turn the lever upwards into the
horizontal position to lock the cover.
^ Replace the service panel and press
the upper edge until it clicks into
position.
,
It is important to ensure that both
the condenser unit and the cover
are correctly positioned and locked,
otherwise water may leak from the
dryer.
Cleaning and care
45