Filter
Top Products
Buzzer
The buzzer has two volumes.
Normal
The buzzer sounds at the end of a
programme. (The machine is delivered
with this option set as standard).
Loud
The buzzer sounds at maximum volume
at the end of a programme.
The buzzer will always sound when
there is a fault, even if it has been
switched off.
A tick
L will appear beside the option
to show that it has been set.
Display contrast
Display brightness
There are ten different display
contrast and display brightness
settings.
The bar chart shows you the setting.
Keypad tones
An audible tone sounds each time a
button is pressed.
A tick
L will appear beside the option
to show that it has been set.
The machine is delivered with the
option: Off set as standard.
Standby
To save energy, the display goes out
after 10 minutes and the
Start/Stop
button will start flashing slowly.
There are two options:
Active
(On)
Stand-by comes on:
– if a programme is not selected after
the machine has been switched on.
– when the
Start/Stop
button is
pressed.
–
at the end of a programme.
Not in current prog.
Stand-by comes on:
–
if a programme is not selected after
the machine has been switched on.
Pressing one of the buttons switches
the display back on again.
A tick
L will appear beside the option
to show that it has been set.
The machine is delivered with the
option: On set as standard.
Settings menu J
52