Filter
Top Products
Problem Possible cause Remedy
The following
message
appears after
the programme
has finished:
Clean the filters
Air is not flowing freely
through the dryer.
–
The dryer is not working
efficiently or
economically.
–
Possible causes: The fluff
filters are clogged with
fluff or with detergent
residues.
–
Clean the fluff filters.
If they need to be cleaned
with water, make sure they
are completely dry before
replacing them.
–
See also the notes on the
next page under: "The drying
process goes on too long or
even switches off".
To delete the fault message:
–
Switch the dryer off and then
back on again.
You can adjust the setting
which controls when or if
the message
Clean the
filters
appears.
See Settings menu J, Airways
indicator section.
,
Technical fault
Call the Service
Department
No obvious cause.
In some circumstances,
Clean the filters
will already
have been displayed.
– Clean the fluff filters and the
condenser unit.
To delete the fault message:
– Switch the dryer off and then
back on again.
There is a fault, if despite
doing this, the programme
is cancelled and the fault
message appears again.
Contact the Miele Service
Department.
i
Programme
cannot
be changed
An attempt has been made
to alter a programme while
it is in progress.
You will need to cancel the
current programme before you
can select a new one.
i
Programme finish
time changed
This is not a fault. Settings were changed during a
delay start period, or there has
been a power cut.
Problem solving guide
32