Filter
Top Products
Check and fault indicator messages in the display
Problem Possible cause Remedy
After the beginning of
the programme the
following symbols flash
in the display: "=== ... -==
... == ... ".
This is not a fault. The electronic unit is
calculating the drying time
for the programme (see
“Guide to the appliance”).
The programme has
been stopped, the
Anti-crease/Finish lamp
comes on, and 0 appears
in the display.
This is not a fault.
The electronic unit has
recognised that there is
no laundry in the drum
and cancelled the
programme.
Drying individual
garments or items which
are already dry can also
cause the programme to
be stopped.
Use the "Timed drying -
Warm air" programme to
dry individual items.
Before changing a
programme: Open and
close the drum door.
Shortly before the end of
the programme, the
count down of the time
left to run halted at 6.
Horizontal bars flash but
the dryer continues to
dry.
This might be because:
– items of laundry may
have rolled up
together.
– the types of fabrics
being dried may take
different times to dry.
–
The fluff filter may be
blocked.
–
the temperature in the
room may have
changed.
The drying process is not
yet complete. The
programme needs more
time than the electronic
unit calculated at the start
of the programme. The
time count down is
suspended until the
degree of drying selected
has been reached.
Problem solving guide
28