Filter
Top Products
General problems with the washer
Issue Possible cause Solution
The washer shakes
during the spin cycle.
–
The four feet are not
resting evenly on the
floor.
–
The floor is not
properly reinforced.
–
Level the machine (see
Installation Instructions).
–
It is recommended that
the machine is installed
on a concrete base.
There are unusual
sounds coming from
the drain pump.
There is no fault. Lapping sounds at the beginning
and end of the pump process are normal.
Large residues of
detergent remain in the
dispenser drawer
The water pressure is too
low.
– Check and clean the
filters in the water inlet
hoses.
– Select the "Water plus"
Extra if desired.
Water softening
detergent additives tend
to clump.
Clean the detergent
drawer. In the future add
the detergent first and then
the water softener to the
compartment.
The fabric softener is
not completely
dispensed or too much
water remains in the
compartment §.
The siphon tube is either
incorrectly positioned or
clogged.
Clean the siphon tube, see
"Cleaning and care-
Cleaning the detergent
dispenser drawer".
The display shows a
foreign language.
A different language was
selected under
"Settings-Language J".
Select the desired
language. The flag symbol
leads you to the setting.
Frequently asked questions
36