Filter
Top Products
Levelling the machine
The machine must be perfectly level to
ensure safe and proper operation.
^
The screw feet can be adjusted to
compensate for any unevenness in
the floor.
,
The air inlet and outlet vents on
the front and back of the machine
must not be covered as this would
prevent sufficient ventilation for
cooling the condenser unit.
Room ventilation
The air which is taken in when the
dryer is in operation is blown out of
the vents on the front of the machine
and warms up the air in the room.
It is very important, particulary if the
room is small, to ensure adequate
ventilation. Opening a window, for
example, will allow more air to enter
the room. Otherwise running times
and energy consumption could be
increased.
Before moving the machine again
(e.g. when moving house)
After each use a small quantity of
condensed water will collect in the area
around the pump. This water can run
out if the machine is tipped up when it
is being moved. It is a good idea to run
the Cool air programme for
approximately 1 minute before moving
the machine. Any remaining condensed
water will then be fed into the
condensed water container or out
through the drain hose.
Installation and connection
40