Filter
Top Products
What to do if, . . . Cause . . . Remedy . . .
. . . The “Check lights” are
flashing
Too much foam has built up.
The “Excess detergent” light is
flashing.
– Use less detergent next time,
and follow the
recommendation on the
packet.
– Take the water hardness
level into account.
– Use a different suitable low-
lather detergent
. . . in the “SEQUENCE” dis-
play one of the following light
blocks is flashing:
– “Soak / Pre-wash”
– “Main wash”
– “Rinses 1 - 2
–“Rinse 3
There is a fault. Start the programme again. If
the light block starts flashing
again, call the Service dept.
. . . The wash programme fin-
ishes prematurely and three
horizontal dashes “- - -” ap-
pear in the display
There is a fault. Restart the programme. If the
horizontal dashes reappear call
the Service Dept.
. . . In the SEQUENCE col-
umn the “Final spin” light is
flashing
The final spin has not taken
place. The machine detected
an imbalance.
– Loosen the laundry load.
– Press the Drain/Spin touch
pad in the ADDITIONAL
OPTIONS column.
– Select the spin speed
required.
– Press the START touch pad.
. . . The washing has not
been spun satisfactorily
The spin speed selected was
too low.
Select a higher spin speed next
time.
The load was not distributed
sufficiently evenly in the drum.
To protect the machine laundry
was only spun at a reduced
speed.
Always mix large and small
items in the load.
The fluff filter is clogged. Clean the fluff filter.
Problem solving guide
30