Filter
Top Products
Levelling the machine
The machine must be perfectly level to
ensure safe and proper operation.
Incorrect installation may increase
water and electricity consumption.
The screw feet can be adjusted to level
the machine.
Unscrew the foot or feet until the ma-
chine stands level.
Hold the foot tight using a pipe
wrench.
Tighten the counternut using a
screwdriver as indicated.
Building under
To install this appliance under a (con-
tinuous) worktop:
A special building under conversion
kit* is required.
The machine lid must be replaced
by a cover plate.
To ensure electrical safety the cover
plate must be fitted by a suitably
competent person exactly according
to the fitting instructions included
with the kit.
Fitting instructions are supplied with
the conversion kit.
For installation under a work surface
900/910 mm from the floor, a raising
kit* is required.
Connections for electricity, water and
drainage should be installed in such
a way that they remain accessible
when the machine is in place.
Installation
38