Filter
Top Products
15
TROUBLESHOOTING
First try the solutions suggested here or visit our website to possibly avoid the cost of a service call.
In U.S.A. www.maytag.com/product_help – In Canada www.maytag.ca.
If you experience Possible Causes Solution
Washer not performing as expected (cont.)
Washer won’t run
or fill, washer stops
working (cont.)
Check proper electrical supply. Plug power cord into a grounded 3-prong outlet.
Do not use an extension cord.
Ensure there is power to outlet.
Reset a tripped circuit breaker. Replace any blown fuses.
NOTE: If problems continue, contact an electrician.
Normal washer operation. Lid must be closed for washer to run.
Washer will pause during certain phases of cycle.
Do not interrupt cycle.
Washer may be stopped to reduce suds.
Washer may be tightly packed. Remove several items, rearrange load evenly around the
washplate. Do not load garments directly over the center
of the wash plate. Close lid and press START/PAUSE.
Add only 1 or 2 additional garments after washer has started.
Do not add more water to the washer.
If you experience Possible Causes Solution
Washer not performing as expected
Not enough water
in washer
Load not completely covered
in water.
This is normal operation for an HE low-water washer. The load will
not be completely under water. The washer senses load sizes and
adds correct amount of water for optimal cleaning. See “What’s
New under the Lid.”
IMPORTANT: Do not add more water to washer. The added water
lifts the load off the washplate, resulting in less cleaning.
Washer won’t run or fill,
washer stops working
Check for proper water supply. Both hoses must be attached and have water flowing to inlet valve.
Both hot and cold water faucets must be turned on.
Check that inlet valve screens have not become clogged.
Check for any kinks in inlet hoses, which can restrict water flow.