Filter
Top Products
16
3. Reassemble the inner and outer door assemblies with the 6 screws.
4. Replace the 2 handle screws for the door handle of the door assembly.
5. Remove the plug strip or label.
Style 1: Remove the plug strip.
■ Use a small flat-blade screwdriver to remove the plug strip in the door opening. Slide
the head of the screwdriver under the top portion of the plug strip, being certain not to
scratch the dryer surface. Lift up. Repeat in the middle and at the bottom. Remove the
plug strip in the door opening and insert in the opposite side.
Style 2: Remove the label.
■ Peel off the label located on the opposite side of the door opening covering the hinge
mounting holes. Apply the label over the original hinge holes.
6. Insert a screw in the second opening from the top of the hinge opening and partially
tighten. Hang the door by placing the top hinge keyhole over the second screw head and
tighten the screw. By putting this screw in first, the door will hang in place while you
insert and tighten the remaining 4 screws.
7. Close the door and check that it latches securely.
Complete Installation
1. Check that all parts are now installed. If there is an extra part, go back through the steps to
see which step was skipped.
2. Check that you have all of your tools.
3. Check the dryer’s final location. Be sure the vent is not crushed or kinked.
4. Check that the dryer is level. See “Level Dryer.”
5. Plug into a grounded 3 prong outlet. Turn on power.
6. Remove any protective film or tape remaining on the dryer.
7. Dispose of/recycle all packaging materials.
8. Read “Dryer Use.”
9. Wipe the dryer drum interior thoroughly with a damp cloth to remove any dust.
A. Dryer door
B. Dryer
C.Insert this screw first.
A
B
C
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING