Filter
Top Products
m LOAD THE DRYER
A washer load is a dryer load. A full load is shown at
right. Remember, clothes take up more space as they
fluff dry. Proper tumbling is important, so when you dry
very small loads, add a few similar dry items.
Be sure to remove safety pins, hair pins, etc., to prevent
damage to articles being dried.
IMPORTANT
The following items should not be dried in a dryer unless
specifically recommended by the manufacturer on the
hang-tag or label.
1. Fiber glass articles (curtains, draperies, bedspreads,
etc.)
2. Woolens
3. Rubber-coated items, plastics and articles with plas-
tic trim (on a heat setting).
DIGITAL DISPLAY
SHUTS DRYER OFF AND CANCELS ALL
SELECTIONS
LIGHT INDICATES WHEN COOL DOWN BEGINS
OR AIR FLUFF IS SELECTED
TURNS AUDIBLE SIGNAL ON AND OFF
I II II I
DRYING CYCLE INCREASES OR
CYCLE OPTIONS DECREASES
PROGRAMS DRYNESS LEVEL
OR DRYING TIME
The right portion of the computer touch control panel programs the dryer. The dryer selections can be seen at a glance. Red
indicators light up in the pads of the programmed selections.
This dryer has the capability of operating in an Electronic Dry mode (senses moisture and shuts off automatically when proper
dryness is reached) or in a Timed Dry mode (you set the dryer to run for a specific length of time).
When using the Electronic Dry mode for regular and permanent press loads, the display will show the programmed dryness
setting until the end of the program when the display will change to count down the remaining minutes of cool-down. When
using the Timed Dry option or Air Fluff program, the display will count down the minutes. A "Cool" indicator light is on
whenever the dryer is in cool-down or operating on Air Fluff.
Selections can be easily and quickly changed. The Regular or Permanent Press program can be changed by touching either
dryer program pad. Once Air Fluff has been selected, it is locked in. It can be changed, however, by touching the "OFF" pad
which cancels all selections. Then another selection can be made. Options can be added by touching the pad once or canceled
by touching the pad again. The "MORE" and "LESS" pads are pressed to lengthen or shorten a timed program or to change
the dryness setting of an electronic dry program.
Opening the dryer door will interrupt the dryer program but will not cancel it. To resume operation close the dryer door and
touch the program pad with the blinking indicator light.