Filter
Top Products
Im
SELECT WASH CYCLE
For Regular Fabrics, touch the center of the "Regular" pad. The washer will immediately begin fill-
ing, automatically selecting a "Large" load, Warm Wash/Cold Rinse, and 10 min. of_agitation. ("10"
will appear in the Digital Display.)
For Permanent Press Loads, touch the "Permanent Press" pad. The washer will immediately begin
filling, automatically selecting a "Large" load, Warm Wash/Cold Rinse, and 8 min. of agitation. ("8"
will appear in the Digital Display.) This cycle can also be used for nonpermanent press items when two
deep rinses are desired.
For Delicate Loads (delicately constructed knits, sheer fabrics, lace trimmed and embroidered ar-
ticles, lingerie, foundation garments, washable woolens, and "Hand Washable" items) touch the
"Delicates Knits" pad. The washer will immediately begin filling, automatically selecting a "Large"
Load, Warm Wash/Cold Rinse, and 6 min. of alternate periods of soak and agitation. ("6" will appear
in Digital Display.)
You can change back and forth to any wash cycle until wash fill is complete.
NOTE: WASHER LID LOCK
This washer is equipped with a lid lock. Any time the washer is on and the lid is closed, the lid
lock is engaged. The lid will unlock immediately during fill or agitate when either the
"Pause/Resume" or "Off" pad is touched. If the washer is in the spin mode, and the
_'Pause/Resume" or "Off" pad is touched, there will be a six second delay before the lid
unlocks to assure the tub has stopped spinning. The washer will not agitate or spin with the lid
open but will fill with water. (See pg. 5, Pause/Resume)
2, SELECT LOAD SIZE
Since the "Large" load is automatically selected you only need to change the load selection if you are
washing a medium or small load. You can, however, change back and forth from any load size by
touching the "Large", "Medium" or "Small" pads.
Remember, for best washing results, clothes must circulate freely. If too little water is used, it may
result in poor washing action and in certain cases, it may create wear on fabrics being washed.
SMALL--Use this setting when tub is less than 1/2 full of clothes. Tub fills with 11 gallons (9 Imperial
gallons; 42 liters).
This level of water is below where the lint filter can function.
MEDIUM--Use this setting when tub is from 1/2 to 3/4 full of clothes. Tub fills with 13 gallons (11
Imperial gallons; 49 liters).
LARGE--Use this setting when tub is from 3/4 to full of clothes. Tub fills with 16 gallons (13 Imperial
gallons; 61 liters).
NOTE: When laundering permanent press garments or garments of delicate construction, washable
woolens or loosely knit articles, never use less than the "Mediur_" setting. This will minimize
shrinkage, wrinkling and pulling of seams.
1 SELECT WASH/RINSE TEMPERATURE
Since a Warm Wash/Cold Rinse is automatically selected with all wash cycles, you only need to
change this selection if you want a Hot Wash, a Cold Wash or a Warm Rinse.
Touch the "Hot" or "Cold" pad if you want a hot or cold wash temperature. Touch the "Warm Rinse"
pad for a warm final rinse (spray rinse will always be cold), except for the permanent press program
where the final rinse will always be cold. Changes in wash and rinse selections can be made until the
fill for wash or rinse is complete.
NOTE: Indicator lights on the left edge of each pad will be illuminated when that selection is made.
The indicator light will go out when that selection is canceled. The indicator lights as shown
on Page 3 indicates the washer is in the Regular cycle, on the large load size, and. Warm
Wash!Cold Rinse.