Filter
Top Products
a
a
ADD FABRIC SOFTENER, if desired
Add recommended amount to cup in top of agitator.
The cup may be lifted out for easy filling. Add water to
bring liquid level just below openings at the rim of the
cup° Diluted fabric softener will automatically be added
to the final rinse°
When using fabric softener, do not interrupt the spin
following wash because the softener will go into the
washbasket at the wrong time.
Periodically clean the cup and the cap of the filter with
hot water and a soft brush or cloth.
NOTE: Do not add fabric softener when using Soak
Only, Rinse or Spin programs.
Slide the lid completely forward and you are now ready
to set the control°
DIGITAL DISPLAY
SHUTS WASHER OFF
AND CANCELS ALL
SELECTIONS
SEQUENCE LIGHTS
I II II II II II I
WASH SPECIAL LOAD WASH/SOAK SPECIAL INCREASES OR
CYCLE PROGRAMS SIZE TEMP. OPTIONS DECREASES AGITATION.
PROGRAMS SOAK OR SPIN TIME
The left portion of the computer touch control panel programs the washer. The washer selections can be seen at a glance. Red
indicators light up in the pads of the programmed selections.
Also, the progress of the washer program can be monitored. Red sequence lights for each portion of a program -- SOAK,
WASH, RINSE, SPIN -- light up in sequence as the washer operates. The number of minutes remaining in each portion of a
program appears in the Digital Display.
Selections can be easily and quickly changed. A Washer Program, Load or Water selection is changed by touching another
pad. Options are selected by touching the pad once or canceled by touching the pad agaim The "MORE" and "LESS" pads
are pressed to lengthen or shorten a portion of a program. Touching the "OFF" pad stops the washer and cancels all selec-
tions.
The washer signal consists of 2 consecutive electronic tones. The signal will sound once every minute if the washer has stopped
due to an unbalance condition, or if the washer cycle has not been resumed after a pause during the wash fill. It is necessary to
return to the washer to resume the cycle. There is no signal at the end of the washer program.
IMPORTANT: If you select a washer program while the lid i_ open, an "L" will appear in the
display and you must touch the "Pause/Resume" pad after closing the lid. If you
do not touch the "Pause/Resume" pad after closing the lid, the washer will stop
after filling and an electronic tone will sound twice every minute.