Filter
Top Products
22
ERROR SYMPTOM CAUSE
1 WATER INLET Water has not reached to the pre-set level within 4 min. since
ERROR inlet valve operated, or water has not reached to the normal
level within 25 min.
2 IMBALANCE The appliance is tilted.
ERROR Laundry is gathered to one side.
Non-distributable things are put into the drum.
3 DRAIN ERROR Water has not drained enough within 5 min.
4 OVERFLOW Water is automatically being pumped out because too much
ERROR water is in the tub.
5
SENSOR PRESSURE
S/W ERROR
The sensor pressure switch is out of order.
6 DOOR OPEN The
Start/Pause
button is pressed with the door open.
ERROR The door switch is out of order.
7 HEATING The thermistor is out of order.
ERROR
8 SENSOR The connector (5-pin, male, white) in the wire harness is not
ERROR connected to the connector (5-pin, female) of hall sensor in
the MOTOR.
’ Reconnect or repair the contact in the connector.
8-4. ERROR DISPLAY.
■ WD-1223(5)F(H)(B)/WD-1243(5)F(H)(B)/WD-102(4)1(5)WF(H) / WD-1041(3)F(H)B
If you press the Start/Pause button when an error in displayed, any error except
will disappear and the machine will change into pause status.
In case of if the error is not resolved within 20 sec. In the case of other
errors,
if the error is not resolved within 4 min. power will be turned off automatically and the error code will blink.
imbalance
no drain
no inlet