Filter
Top Products
10
5. OPERATION
(Wash) (Rinse) (Spin) (Water Temp) (Time Delay)
Pre
RH
S
N
T
T
Main
1200(1000)
1000(800)
800(600)
600(400)
no Spin
50
30
40
Cold
60
95
How to set the Function
Rinse hold
• Rinse hold function can be selected by pressing the rinse
( ) button, and rinse hold lamp turns ON.
• Selection rinse hold washer waits without drain / spinning
after rinse.
• To drain and spin, press rinse ( ) button, rinse hold lamp
turns off and drain / spinning starts.
How to select water temperature
• Press the button to select water temperature.
• The water temperature can be selected
[40°C 50°C 60°CCold 30°C ] during
coloreds, or synthetic programs.
• 95°C is selected only for whites program.
• By pressing the button while operating the
present temperature is displayed.
How to use delayed washing
• Press the button when reservation washing is needed.
• When the button is pressed, 3:00is displayed. A maximum
delay of 19:00hours can be set.
• Whenever pressing it, one hour increases.
• Time delay the power ( ) button to cancel it.
• Time delay means the time required from the present to the
completion of washing.
Displaying abnormal operation
• Display the remaining time (Hour : Minute)
• The remaining time is reduced by
the washing cycle.
• Error lamp is indicated the abnormal operation.
()
• Display the reservation time.
For manual wash,
rinse, and spin
• Use these buttons to change
washing method, rinse
method spinning speed.
• When lamp is off, no selection
has been made.
• Prewashing is available for
coloreds, whites, and
synthetic program.
■ WD-1223(5)F(H)(B) / WD-1243(5)F(H)(B)
WD-1041(3)F(H)B / WD-102(4)1(5)F(H)B
,,,,,
,