Filter
Top Products
REVIEW INSTALLATION
Take a few minutes to complete
this checklist. It wil! help assure you
that you have a proper installation
and increase your satisfaction with
your Kenmore dryer,
[] Check that all parts you removed
from the parts packages are now
installed.
[] Ensure that dryer is positioned in its
final location. Make sure vent is not
crushed or kinked.
[] Ensure that dryer is level by placing
a level on top of the dryer. Check side-
to-side first, then check front-to-back.
If dryer is not level, adjust the legs up
or down.
[] Check to make sure you have all
the tools you started with.
FINAL STEPS
[] Plug the power supply cord into the
grounded outlet or connect direct
wire to power supply.
[] Turn power supply on.
[] Wipe the interior of the drum
thoroughly with a damp cloth to
remove any dust.
[] Remove the blue protective film on
the console and any tape remaining
on dryer.
[] Take a few minutes and read the
Operating Instructions (pgs. 29-35)
to fully understand your new dryer.
[] Start the dryer and allow it to
complete a full heat cycle (not the
AIR DRY Cycle). After five minutes,
open dryer door. You should feel
heat inside the dryer. If you do not
feel heat, see "TROUBLESHOOTING"
on pages 41-42.
NOTE: You may notice a burning odor.
This smell is common when the heating
element is first used. The smell will go
away.
28