Filter
Top Products
ALTERNATECONNECTION:
Iflocalcodesdonotpermitthe
connectionofaframe-grounding
conductortotheneutralwire:
STEP1.Disconnectpower.
STEP2.Makesurethepowersupply
cordordirectwire cable is in place
(see STEPS 1-3 on page 14 for power
cord connections or STEPS 1-3 on
pages 15-16 for direct wire connection).
STEP 3. Remove the neutral grounding
wire (green/yellow wire) from external
grounding connector screw. Loosen or
remove terminal block screws. Connect
neutral grounding wire and the neutral
wire (white or center) of power supply
cord or direct wire cable under the center
screw of the terminal block.
STEP 4. Connect the other two wires
to outer terminal block screws. Securely
tighten all electrical connections.
STEP 5. Tighten the strain relief screws.
STEP 6. Insert tab of terminal block
cover into slot of the dryer rear panel.
Secure cover with hold-down screw.
STEP 7. Connect separate copper
grounding wire from external ground
connector to an adequate ground. If
codes permit and a separate grounding
wire is used, it is recommended that a
qualified electrician determine that the
grounding path is adequate.
Proceed with installation on page 23.
External
ground
Neutral
gr0unding wire
(green/yell0w)
Groundingpath
determined by a
qualified electrician
Alternate 3=Wire Connection with
External-Grounding Conductor
17