Filter
Top Products
KEY DIMENSIONS AND SPECIFICATIONS
Description Front-Loading Washer
Rated Voltage/Frequency 120 VAC @ 60 Hz.
Dimensions 27" (W) X 293/4" (D) X 3811/1e"(H), 511/8" (D, door open)
68.6 cm (W) X 75.6 cm(D) X 98.3 cm(H), 129.8 cm (D, door open)
Net Weight 190 Ib. (86 kg)
CHOOSE THE PROPER LOCATION
WARNING
• Washer is heavy[ Two or more _ople are required
when moving and unpacking the washer. Failure to do so
may result in damage to property or _dous bodily harm.
• Store and install the washer where it will not
exposed to temperatures below freezing or exposed to
outdoor weather conditions. Failure to follow this warning
can cause _rious injury, fire, electrical sho_, or death.
• Properly ground washer to conform with all governing
codes and ordinances, Failure to follow this warning can
cause serious injury,fire, electrical shock, or death.
• To reduce the risk of el_tric shock, do not install the
washer in humid spaces. Failure to follow thiswarningcan
cause serious injury,fire, electrical shock, or death.
• The base opening must not be obstructed by carpeting
when the washer is installed on a carpeted floor.
• Do not remove ground prong, Do not use an adapter or
extension cord, Plug into a grounded 3-prong outlet,
Failure to follow this warning can cause _rious injury, fire,
electrical shock, or death.
Power Outlet
• The power outlet must be within 60 in. (1.5 m) of either side
of the washer.
• The appliance and outlet must be positioned so that the
plug is easily accessible.
• Do not overload the outlet with more than one appliance.
• The outlet must be grounded in accordanoe with current
wiring codes and regulations.
• Time-delay fuse or circuit breaker is recommended.
NOTE: it is the persona] responsibility and obligation of the
productowner to have a proper outlet installed by a qualified
_r¢ice person.
FLOORING
• To minimize noise and vibration,the washer MUST be
installed on a solidly constructed floor. See the NOTE at
right.
• Allowable slope under the entire washer isa maximum 1"
difference from side to side or from front to back.
• Carpeting and soft tile surfaces are not recommended.
• Never install the washer on a platform or weakly supported
structure.
CLEARANCES
(54.2 cm)
.....................................293/4 ''_ _ 4"
(75.6 cm) (10 cm)
511/s"
(129.8 cm)
To ensure sufficient clearance for water lines and airflow,
allow minimum clearances of at least 1 in. (2.5 cm) at the
sides and 4 in. (10 cm) behind the unit. Be sure to allow for
wall, door, or floor moldings that may increase the required
clearances.
rq
(2.5 cm) (68.6 crn) (2.5 crn)
Allow at least 21_/4in. (54 cm) in front of the washer to open
the door.
NOTE: Please note that the floor must be strong and rigid
enough to support the weight of the washer, when fully
loaded, without flexing or bouncing. If your floor has too
much flex in it, you may need to reinforce it to make it more
rigid. A floor that is adequate for a top-loading washer may
not be rigid enough for a front loadingwasher, due to the
difference in the spin speed and direction. If the floor is not
solid, your washer may vibrate and you may hear and feel
the vibration throughout your hour.
7