Filter
Top Products
CONNECTING THE DRAIN HOSE
•The drain hose should always be properly secured
Failure to properly secure the drain hoe can result Jn
flooding and property damage.
• Do not in,aft the end of the drain hose higher than 96 in.
(244.8 cm) above the bottom of the washer.
•The drain must be installed in accordance with any
applicable local _des and regulations.
• Make sure that the drain hose is not stretched, pinched,
crushed, or kinked.
NOTE:
A drain hose extension kit is
available if the drain hoe is not
long enough. Do not extend
drain hoe more that 6 feet, as
this wifl cause poor draining
resumingJnpoor wash and spin
performance.
Option 1: Standpipe
Elbow Bracket
The elbow bracket should be installed near the end of the
drain hoE. Insert the end of the drain hose into the
standpipe. Use tie strap to secure the drain hose in place.
NOTE:
•Total height of the hose end should not exceed 96 in.
(244.8 cm) from the bottom of the washer.
•The drain hose should be inserted no more than 8-12
inches into the standpipe.
NOTE: Ifthe drain hose is extended more than 4 inches
beyond the end of the end of the elbow bracket, mold, or
microorganisms could spread to the inside of the washer.
Option 2: Laundry Tub
Elbow Bracket
The elbow bracket should be installed near the end of the
drain hose. Hang the end of the drain hose over the side of
the laundry tub. Use tie strap to secure the drain hoe in
place.
Option 3: Floor Drain
Drain Hose
Floor Drain
insert the end of the drain hose into the floor drain.
Secure the hose to prevent it from moving.
CONNECT TO POWER SUPPLY
Washer should be plugged into a 120-VAC, 60-Hz.
grounded 3-prong outlet.
Plug in the washer.
,,,J
J
10