Filter
Top Products
iiiii ii ii i!ii!ii!i ii!iiiiii!
ijjii!ii!!!!!ii i!i!!ili!
iiiiiiiiiiiiiiiiiiiiiii!iiiii!i iiii!i!ili!ii!iiii
iiiiiiiiiiiiiiiiiiiiiiiiiii,_iiiiiiii_ii_ii_ili
BEFORE CALLING FOR SERVICE (conL)
The display shows:
Check if...
Loadis too sma&
Load is out of balance.
Then,,,
Add 1 or 2 similar items to help balance the Ioa&
Pause the cycle and redistribute the load after the door unl_ks.
The washer has an imbalance detection and correction system If
individual heavy articles are loaded (bath mat, bath robe, etc) and
the imbalance is too great, the washer wi]] make severai attempts to
restart the spin cycle. Jfan imbalance is still detected, the washer wi]]
stop and the error code will be displayS.
The display shows:
Ch_k if...
Control error.
Then...
Unplug the washer and wait 60 seconds. Reconnect power and try
again. If the error reappears, call for service.
The display shows: FE
Check if...
I Water levelis too high due to a fau_j water valve.
The display shows: pE I
Check if...
I The water level sensor is not working correcUy.
Then.,,
I Close the water the washer, and call for service.
taps,
unplug
Then,.
I Close the water the washer, and ca][for service.
taps, unplug
The display shows:
Check if...
LE
Thermal overload protectiondrcuit in the motor has been
tripped.
Then,,,
Allow the washer to stand for 30 minutes to allow the motor to cool;
then restart the cycle. Ifthe LE error code persists, call for service.
The display shows:
Check if.,,
A powerfailure haso_urred.
Then,,,
If the power to the washer has been interrupted during a cycle, the
"PF" error code wi]]be displayed the next time the washer is turned
on. This will alert you to the fact that the previous cycle may not
have been completed. Select any cycle to dear the error code and
use the washer.
28