Filter
Top Products
7
Delicates
Use this cycle for lightly soiled knits and delicates which
require gentle washing.
Handwash
Use this cycle to provide intermittent, gentle tumbling for
items labeled “Hand Wash”.
Rinse & Spin
Select Rinse & Spin for loads that need a cold water
rinse or to add fabric softener that may have been omit-
ted in a regular cycle. Add the fabric softener to the
dispenser chamber. Select the spin speed appropriate
for the load.
As a precaution, the washer door is locked once the
water temperature reaches 130° F (55° C). If the cycle is
cancelled during the wash phase and the water temper-
ature is greater than 150° F (66° C) an automatic cool
down rinse will occur before the door can be opened.
Cold Clean
Designed for a small load of mixed items, wash and
rinse temperatures are equivalent to temperature of cold
tap supply. Use this selection for fabrics and colors that
are prone to dye transfer. Best used with cold water
detergent.
Silk
Select this cycle for washable silk items. It will provide
gentle reversing tumble wash action in cold water and
multiple rinses. Chlorine bleach will not be dispensed
in this cycle. The water will drain out at the end of the
cycle, but the drum will not spin. The garments will be
very wet.
Cycle Selection, continued
Express Wash
Quickly wash a small, lightly soiled load in 18 minutes.
Express Sanitize
Use the Express Sanitize cycle to clean and sanitize
heavily soiled, colorfast fabrics including towels, bed-
ding, cloth diapers, and children’s clothing.
It is recommended that you set your water heater to 120°
F (49° C) or higher to ensure proper performance during
this cycle. If the setting is lower or the load is extra large,
the cycle time may be extended.
The Express Sanitize cycle will kill 99.9% of bacteria
with no carryover of bacteria between loads. No bleach
or harsh chemicals are needed, but higher temperatures
are required. Please check fabric care labels to prevent
damage.
NSF Protocol P172
Sanitization Performance of Residential
and Commercial, Family-Sized Clothes
Washers
The wash water is heated by an internal boost heater to
a maximum of 152° F (67° C) as the load tumbles.
is displayed during the wash phase alternately with the
estimated cycle time. Cold water is added to cool down
the load prior to drain and spin.
Operating Instructions
NOTE
Washing silk garments labeled “
Dry Clean Only
” or
using chlorine bleach can result in permanent damage.
NOTE
You may deselect Extra Rinse if you wish to perform a
Spin Only cycle or select No Spin if you want to perform
a Drain Only cycle.
NOTE
If the voltage at your outlet is under 110 v, the internal
heater may not adequately heat the wash water. If
the cycle is interrupted while the water is heating, the
fi nal temperature of the wash water may be lower and
sanitation may be reduced.
NOTE
This cycle has been certifi ed by NSF International,
an independent third party testing and certifi cation
organization dedicated to public health, safety and
environmental protection.
Clean Washer
To clean and freshen the washer, perform the Clean
Washer cycle. If you wish to begin the cycle, empty the
drum, add bleach and press START. This maintenance
cycle removes residue that may cause odor. See
Inside
Routine Cleaning (Preventive)
for detailed information
about the Clean Washer cycle.