Kenmore 3405594 Washer/Dryer User Manual


 
Problem Possible Cause Solution
Won't Drain/ Low voltage or using Check electrical source or call
Won't Spin/ an extension cord. electrician. Do not use an extension
Wet Loads cord.
(cont'd)
Cold rinses, Cold rinses leave loads wetter than
warm rinses. This is normal.
Continues Drain hose is less than Raisethe drain hose
to Fill/ 39 inches above floor. (see "INSTALLATION','Section D).
Continues
to Drain/ Drain hose fits tightly into Adjust drain hose for loose fit
Cycle Stuck standpipe. (see "INSTALLATION','Section D).
Drain hose taped into Do not seal off drain hose with tape.
standpipe. The drain hose needs an air gap.
Washer Makes Load is unbalanced. Redistribute load.
Noise
Laundry center is not level. Level laundry center
(see "INSTALLATION','Section I).
Floor not strong enough Relocate laundry center
to support laundry center. (see "INSTALLATION','Section A).
Gears engaging after drain This is normal.
and before spin.
Upper part of agitator clicks This is normal.
during wash.
Won't Fill/ Water inlet valve Clean screens.
Won't Rinse/ screens are plugged.
Won't Agitate/
Wrong Water is turned off. Turn on water.
Temperature Hot and cold hoses are Reverse hoses
reversed. (see "INSTALLATION','Sections E & F).
Inlet hose is kinked. Straighten hoses.
Timer dial is not lined up. Turn timer knob to the right slightly
and pull to start.
Power cord not plugged in. Plug in power cord.
55