Filter
Top Products
STANDARD OFFSET
CONNECTIONS
Using 4-inch rigid heavy metal vent:
NOTE: Do not secure exhaust vent
joints with screws, Screws can catch
lint and slow the drying process.
Instead, use clamps to secure exhaust
vent joints.
STEP 1. Install a 4-inch metal elbow
on the hood and on the laundry center's
exhaust outlet.
STEP 2. Measure the length of 44nch
rigid heavy metal vent needed to connect
the two elbows.
Dryer
Rigid = _ (_
heavy_ _
a,
Ducttape ._
& clamps
_Well
f Elbow
Duct
tape &
"=" clamps
,- STEP 2
-, Elbow
" Exhaust
hood
The vent usually comes in 2-foot lengths.
Use tin snips to cut the vent 3 inches
longer than your measurement in order
to make a connection.
STEP 3. Place a clamp on each end of
vent elbow and connect elbow to your
laundry center's exhaust outlet, Tape the
joint with duct tape. Tighten clamp.
Tape
STEP 4. Connect vent to elbow. Tape
the joint with duct tape. Tighten clamp.
STEP 5. Install one end of elbow on
vent, the other end to the exhaust hood.
Tape joints and tighten clamps.
NOTE: Once the exhaust vent is corn
nected and the laundry center is in its
final location, check to make sure the
laundry center is still level (see section
'11'LEVEL LAUNDRY CENTER).
Finish Installation. See "REVIEW
INSTALLATION" on page 33.
3O