Filter
Top Products
6
Multi-Display (4)
4.1 Temperature indicator: the provided washing
temperatures are 95° or 90°- 60°- 50°- 40° - 30°.
Cold corresponds to cold washing.
4.2 Spin speed indicator - «Rinse hold» and
«QUIET» options
Note! The spin exclusion is indicated by a «
0».
4.3 Available options: Easy iron, Intensive, Stain and
Prewash. The rectangle around an option appears
when the option is selected, disappears when the
appliance starts operating (after pressing button
10).
4.4 Extra rinse option.
4.5 Cycle duration calculating symbol:
when
selecting the «proportional» programmes, the
display shows the washing duration of the
maximum recommended load. After the button
10 has been pressed, on the display
the «Wash
time» (4.7)
starts blinking and the animated
symbol 4.5 appears to indicate that the appliance
is calculating the laundry amount and the real
duration. During this time, the washing duration
shown decreases.
When the calculating phase has
finished, the «Wash time» stops blinking, the
animated symbol 4.5 disappears and the washing
time is adjusted to the real load.
4.6 The following pieces of information are
shown on the display.
•
Duration of the programme in hours and
minutes, after you have selected a programme
(ex. 2.05).
While the programme is running
(after you have pressed the button 10), the
displayed time value decreases by one unit every
minute.
•
The washing machine has completed the
programme: this is indicated by a blinking
zero (
0). The «Door Lock» pilot light (11), the
pilot light of button 10 go out and the door can
be opened.
•
The washing machine has stopped with
water in the tub, at the end of a programme
with the «Rinse hold» or «Quiet» option: this is
indicated by a blinking zero. The light of
button 10 goes out but the pilot light 11 is still
on. The door cannot be opened. Note! If your
laundry is not removed within 10 minutes after
the programme has finished, all pilot lights and
the display switch off and the energy saving
system will be enabled. Only the green light of
button 10 blinks to indicate that the appliance
has to be switched off. By pressing any buttons
the appliance will come out from the energy
saving status and you could set another washing
programme or switch off the appliance. The
STAND BY status is incompatible with the
«Delay start» option.
•
Delay start, a time value indicated in hours
(ex.15h) and selected by pressing button 12.
The delay time (20 hours max) is displayed for a
few seconds, then the duration of the selected
programme reappears. After you have pressed
the button 10, the countdown is updated every
hour, and, for the last hour, every minute.
•
An incorrect option selection has been
made: this is indicated by the message «Err»
for about a few seconds when a function
incompatible with the current programme is
selected.
•
An alarm code indicates a fault with the
machine (ex.
E20, see the relevant chapter).
4.8
Cold
Rinse hold
Easy Iron
Quiet
Intensive
Stain
Prewash
Extra Rinse
Delay start
Quick
Wash time
4.1
4.9
4.2 4.3 4.4 4.5 4.6
4.7
4.10
Display and buttons
132961440.qxd 25/08/2008 11.49 Pagina 6