Filter
Top Products
11
If you have chosen a delayed start, the washing machine
will begin the countdown.
The display will show the duration of the programme
or the selcted delay.
Programme correction
As long as the wash programme has not been started
yet, the programme selection can still be changed.
If the programme has been started, it is only possible to
correct the functions, if the programme is first
interrupted by pressing button
10
. In this case only
some of the following functions can be selected
depending on the programme which is running: Spin
reduction, No Spin, Rinse hold, Easy Iron, Extra Rinse
and Quiet.
If the wash programme is to be corrected by means of
buttons
3, the appliance must first be switched off by
pressing the button
2.
Switch on the appliance, set the new programme and
press button
10 again. The water remains in the tub.
Cancel a programme or switch the
appliance off
If a washing programme that has already started is to
be cancelled, press button
2 to RESET the programme.
All lights and the display go out and the appliance is
switched off. The previously selected programme is
now cancelled. Another programme can now be
selected
.
Note!
If any problems occur as the programme runs, always
first switch the appliance off by pressing button
2
before a new programme is selected. Consider the
temperature to which the washing water may already
have been heated.
How to interrupt a programme
By pressing the button 10, a running programme can
be stopped. The light in the button flashes.
The programme is continued by pressing the button
again.
Opening the door after the
programme has started
The door can be opened while a programme is
running, if certain conditions are fulfilled:
• The washing machine is not in the heating phase
beyond 55°C;
• The level of the water is not high;
If these requirements are met, when you pause the
washing machine, the light
11 goes off and the door
can be opened. If the light
11 remains lit, the door
cannot be opened. In any case, do not force it!
Should it not be possible to open the door, and should
it be absolutely necessary to do so, switch the
appliance off by pressing button
2. After a few minutes,
you can open the door.
Pay attention to the level and temperature of
the water in the washing machine!
When you close the door to restart the programme
select the previous programme by pressing the buttons
3, repeat the options previously selected and press the
button
10.
End of programme
The pilot light of the button 10 goes out. «0» blinks
and the message Wash time disappears from the
multi-display.
The pilot light
11 goes out. The door can now be
opened and the laundry can be removed.
Switch the appliance off by pressing button 2,
before remove the laundry.
If the Rinse Hold or Quiet option has been selected
the pilot light
11 is on, the pilot light of the button 10
goes out and the display shows a blinking «
0».
The door cannot be opened because the water must
be drained.
To empty out the water there are 2 possibilities:
•
Select the draining programme and press the
button
10 : the water is emptied out without
spinning.
• Select the spinning programme. Select the spin
speed by pressing the relevant button and then
press the button
10. The water is emptied out
and the laundry is spun at the selected spin speed.
Switch the appliance off by pressing button 2.
Remove the laundry from the drum and carefully check
that the drum is empty. If you do not intend to carry
out another wash, close the water tap and disconnect
the plug from the socket. Leave the door open to
prevent the formation of mildew and unpleasant smells.
132961440.qxd 25/08/2008 11.49 Pagina 11