Filter
Top Products
17
Reversing the Dryer Door Swing
Open the dryer door. Remove the 4 hinge hole
plugs or screws from the left side of door
opening. Place nearby for future installation.
NOTE: You may need a plastic knife to help pull
out the plugs. Be careful not to scratch the paint.
Remove the four screws that secure the door
hinges to the dryer front panel. NOTE: Remove
1 screw from each of the 2 hinges first. Hold the
door firmly before removing the last 2 screws.
Rotate the door 180° and reinstall the door
hinges to the dryer front panel with the 4 screws.
Install the 4 hinge hole plugs or screws that were
removed in step 1 into the open screw holes on
the right side of the door opening.
4
3
2
1
Replacement Parts
If replacement parts are needed for your dryer, visit
Hotpoint.com, or call GE Parts and Accessories
at 800.626.2002 or contact an authorized parts
supplier.
WARNING: Destroy the carton
and plastic bags after the dryer is unpacked.
Children might use them for play. Cartons
covered with rugs, bedspreads or plastic sheets
can become airtight chambers causing
suffocation. Place all materials in a garbage
container or make materials inaccessible
to children.
WARNING: The instructions in the
manual and all other literature included with
this dryer are not meant to cover every possible
condition and situation that may occur. Good
safe practice and caution MUST be applied
when installing, operating and maintaining
any appliance.
Remove 4 screws—one from each hinge first
Consumer SupportTroubleshooting TipsOperating InstructionsSafety Instructions Installation Instructions