Filter
Top Products
14
DANGER: Improper connection of the
equipment-grounding conductor can result in
a risk of electric shock. Check with a licensed
electrician if you are in doubt as to whether
the appliance is properly grounded.
Grounding must be in accordance with local
codes and ordinances, or in the absence of
local codes, in accordance with the National
Electrical Code ANSI/NFPA No. 70.
For a grounded, cord-connected electric dryer:
The dryer MUST be grounded. In the event of
a malfunction or breakdown, grounding will
reduce the risk of electrical shock by creating
a path of least resistance for electrical current.
If your dryer is equipped with a power supply
cord having an equipment-grounding conductor
and a grounding plug, the plug MUST be
plugged into an appropriate, copper-wired
receptacle that is properly installed and
grounded in accordance with all local codes and
ordinances. If in doubt, call a licensed electrician.
For a permanently-connected electric dryer:
■ The dryer MUST be connected to a grounded
metal, permanent wiring system; or an equipment-
grounding conductor must be run with the circuit
conductors and connected to the equipment-
grounding terminal or lead on the appliance.
For a cord-connected gas dryer:
■ This dryer is equipped with a three-prong
(grounding) plug for your protection against
shock hazard and should be plugged directly into
a properly grounded three-prong receptacle.
Do not cut or remove the grounding prong from
this plug.
2
1
Consumer Support
Troubleshooting Tips Operating Instructions Safety InstructionsInstallation Instructions
Grounding Requirements
Installing the dryer.
Read these instructions completely and carefully.
WARNING: The following are specific
requirements for proper and safe electrical
installation of your dryer. Failure to follow
these instructions can create electrical shock
and/or a fire hazard.
WARNING: This appliance MUST be
properly grounded. Electrical shock can result
if the dryer is not properly grounded. Follow
the instructions in this manual for proper
grounding.
WARNING: DO NOT use an extension
cord with this dryer. Some extension cords are
not designed to withstand the amounts of
electrical current this dryer utilizes and can
melt, creating electrical shock and/or fire
hazard. Locate the dryer within reach of the
wall outlet, taking into account the length
of power cord to be purchased and allowing
some slack in the cord. Refer to Electrical
Requirements in this manual for the proper
power cord to be purchased.
WARNING: A UL-approved strain
relief must be installed onto power cord. If the
strain relief is not attached, the cord can be pulled
out of the dryer and can be cut by any movement of
the cord, resulting in electrical shock.
WARNING: Use copper receptacles only.
NOTE: Dryers operating on 208-volt power supply will
have longer drying times than those operating on
240-volt power supply.
A wiring diagram is located inside the control panel.
Electrical Installation for Electric Dryers