Filter
Top Products
– 12 –
GENERAL OPERATING INSTRUCTIONS
Keep the utensil washer clean to provide best results. Do not allow foreign objects to enter the unit,
especially metallic contaminants.
Do not wash aluminum utensils in the utensil washer. The caustic detergent and high water temperature
will cause aluminum oxide formation (black). Copper utensils may require polishing to remove oxide
formation after exposure to utensil washer cleaning for a period of time. Stainless steel utensils should
clean quickly and easily if the food soil is not baked on.
It may be necessary to scrub or prewash some hard-to-remove substances which may not come clean
in the utensil washer with even a 6-minute washing. For stubborn food soil, a plastic scraper, plastic
abrasive pad, nylon bristle brush or sponge with abrasive surface (Scotch Brite) may be used before
washing in the utensil washer. Never use steel wool on ware to be loaded into the utensil washer. Use
only products formulated to be safe on stainless steel. Rinse items thoroughly after scrubbing to remove
metallic debris.
CLEANING THE UTENSIL WASHER
Disconnect electrical power supply and follow lockout / tagout procedures.
The utensil washer must be thoroughly cleaned at the end of each working shift or at least daily. Never
use steel wool to clean utensil washer surfaces.
Fig. 5
Turn the Selector Switch OFF.
Open the doors and lift up on the drain lever to drain the
tank.
Remove the strainer pan and strainer basket (Fig. 5), and
empty into a waste disposer or garbage container. Wash and
rinse strainer pan and strainer basket thoroughly. Do not bang
strainer pan or basket on tables to remove food soil.
After the tank has drained completely, lower the overfl ow
tube to close the drain. Reconnect the electrical power to
the machine.
Turn the Selector Switch to FILL and press the Start button. The machine will fi ll and rinse any debris into
the tank.
After Fill is complete, turn the Selector Switch OFF, open the doors and lift up on the drain lever to drain
the machine.
Disconnect electrical power supply and follow lockout / tagout procedures.
Remove the overfl ow cover and the overfl ow tube. Wash and rinse the overfl ow tube inside and out.
Thoroughly cleanse and fl ush the interior of the machine. Remove remaining soil with a soft cloth or brush
and a mild cleanser. Rinse again. Do not allow food soil to accumulate in the tank bottom.
Reinstall the overfl ow tube.
Carefully reinstall the strainer pan, strainer basket and drain cover. The opening at the corner of the strainer
pan allows the capillary tube to go into the tank.
On machines with the capillary tube in the tank, use care when assembling strainer pan so the
capillary tube is not damaged during assembly.
Make sure that the wash and rinse arms rotate freely and are free of any obstructions. If any obstructions
are present, remove the wash and rinse arms. Clean the wash and rinse arms under running water in a
sink.
UW50 Untensil Washer 208-240/60/3 Page 23 of 112