Filter
Top Products
– 61 –
6. Remove the four screws holding the washer
control board to the backsplash; then remove
the control board and set it aside.
10. Remove the four screws holding the dryer
control board to the backsplash.
11. Remove the dryer control board and set it
aside.
7. Place a towel over the top surface of the dryer
to prevent scratches to the surface.
9. Disconnect the ribbon at the right of the dryer
control board by pulling the connector at the
end of the ribbon off the metal pins.
Note: Do not disconnect any other wires from
the dryer control board.
Screws
Rear of Dryer
8. Remove the four screws from the dryer
backsplash. Rotate backsplash forward and
lift off.
5. Disconnect the ribbon at the right of the
washer control board by pulling the connector
at the end of the ribbon off the metal pins.
Note: Do not disconnect any other wires from
the washer control board.
Rear of Washer
Screws
Rear of Dryer
Screws
Screws