Filter
Top Products
– 28 –
6. Remove the 13 mm center nut. (Turn
clockwise to remove.) Remove the blower
wheel.
11. Remove the spring straps. Remove the drive
motor from the motor bracket.
Note: The motor bracket is notched, be sure to
align the motor correctly in the bracket when
installing.
Note: The motor shaft has a snap ring, which
prevents the blower wheel from rubbing the back
of the blower housing.
9. Remove the blower housing.
10. With a flat blade screwdriver compress the
open end of the spring strap (one strap on
each end of the drive motor) until it releases.
7. Remove the 3 Phillips head screws from the
center of the blower housing. Remove the
front screw from the dryer base.
8. Remove the remaining 2 Phillips head screws
from the dryer base and exhaust duct.
5. Remove the 2 Phillips head screws that hold
the blower guard in place. Remove the blower
guard.
Top View
Snap Ring
Spring Strap