Filter
Top Products
27
Settings menu
Balance Recovery
When your washer is spinning it can sense if the wash load is out of balance.
It will stop and try to spin up to three times. If the machine still senses an
unbalanced load, there are two options the machine can take:
1. Machine Stops
Your machine is automatically set to the Machine Stops option. When this option
is on, your washer will give a short burst of beeps every five seconds to alert you.
It will then ask you to redistribute the load before continuing the cycle.
Your machine defaults to this setting.
2. Automatic Recovery
Your washer will try to automatically correct the out of balance load. It will fill
with water and ‘agitate’ to redistribute the load before trying to spin again.
To set Automatic Recovery:
Access the Settings Menu (refer page 26).
Scroll to the OUT OF BALANCE RECOVERY option, and press SELECT.
Scroll to select between the two options.
Press SELECT to confirm your selection and return to the Settings Menu.
Alarm Beeps
The number of beeps that signal the end of the cycle can be altered. Choose
between no beeps, five or fifteen beeps.
Access the Settings Menu (refer page 26).
Scroll to the ALARM BEEPS option, and press SELECT.
Use the SCROLL buttons to adjust the number of beeps.
Press SELECT to confirm your selection and return to the Settings Menu.
Screen Brightness
You can adjust the brightness of your screen to suit your individual needs.
Access the Settings Menu (refer page 26).
Scroll to the SCREEN BRIGHTNESS option, and press SELECT.
Use the SCROLL buttons to increase or decrease the screen brightness.
Press SELECT to confirm your selection and return to the Settings Menu.