Fisher & Paykel NZ AU PAC SG Washer User Manual


  Open as PDF
of 44
 
26
Changing pre-set options
Out of balance recovery routine
When your washer is spinning it can sense if the wash load is out of balance. If an out of balance
load is detected, the machine will stop and re-try spinning up to three times. If it still senses an
unbalanced load there are two options the machine can take.
Automatic recovery option
Your washer will try to automatically correct the out of balance load. It will fill with water and
agitate to redistribute the load before trying to spin up again.
Machine stops option
Your washer will stop, give a short burst of beeps every five seconds, and the RINSE or SPIN light
will flash. You must redistribute the load more evenly yourself (use this option if you wish to
conserve water).
Fig.38 Adjusting the Out of balance recovery routine
REGULAR
light on
= automatic recovery
REGULAR
light off
= machine stops
WashSmart™
REGULAR
light on
= automatic recovery
REGULAR
light off
= machine stops
QuickSmart™
Machine information
Specifications
Model Capacity Depth Width Height* Height (lid open)
WA80T65G 8.0 kg 650mm 650mm 1020 – 1050mm 1410 – 1440mm
WA70T60G 7.0 kg 600mm 600mm 1020 – 1050mm 1360 – 1390mm
WA60T56G 6.0 kg 560 mm 560 mm 1020 – 1050 mm 1320 – 1350 mm
WA55T56G 5.5 kg 560mm 560mm 1020 – 1050mm 1320 – 1350mm
WA65T60M (MW613) 6.5 kg 600mm 600mm 1020 – 1050mm 1360 – 1390mm
MW60 6.0 kg 560 mm 560 mm 1020 – 1050 mm 1320 – 1350 mm
WA55T56M (MW513) 5.5 kg 560mm 560mm 1020 – 1050mm 1320 – 1350mm
* Height is measured to the highest point on the console.
Note: WA10T65G, WA85T60G, WA75T56G and WA75T56M models have different capacity
specifications based on country standards. Refer to the serial plate on the back of the product.
Electrical supply: 220 – 240 V, 50 Hz Sinusoidal, 165 W
Inlet water pressure: Max. 1 MPa (150 psi), Min. 34 Pa (5 psi)
Inlet water flow rate: Min. 3 litres/min
Standpipe height: 850 – 1200mm
Note: the exact height of your washer is dependent on how far the feet are inserted into the
base of the machine.
 previous next