Filter
Top Products
What to do if ...
Troubleshooting by yourself
If, during operation, the dryer shows an error (one or more leds flashing on the
control panel), check first of all whether you can remedy the problem yourself by
means of the table below. If you cannot solve the problem: Switch the machine off
and on again. Reset programme. Press the Start/Pause button. If the error is still
shown, please contact our after-sales service and inform them which leds are flash-
ing.
Problem Possible cause Remedy
Dryer does not work.
Mains plug is not plugged in
or fuse is not working
correctly.
Plug in at mains socket.
Check fuse in fuse box
(domestic installation).
Loading door is open. Close loading door.
Have you pressed the Start/
Pause button?
Press the Start/Pause but-
ton again.
Drying results
unsatisfactory.
Wrong programme selec-
ted.
Select a different pro-
gramme the next time you
dry (see “Programme chart”
chapter).
Lint filters clogged. Clean lint filters.
Fluff filter clogged. Clean fluff filter.
Heat exchanger clogged
with lint.
Clean heat exchanger.
Overloading of laundry.
Observe recommended
loading volumes.
Ventilation slots in base area
covered up.
Uncover ventilation slots in
base area.
Residue on inside surface of
drum or drum ribs.
Clean inside surface of drum
and drum ribs.
Conductance of water at in-
stallation site differs from
standard setting of machine.
Re-programme standard
setting for degree of drying
(see ‘Machine settings’
chapter).
what to do if ... electrolux 25