Filter
Top Products
Drying cycle complete / removing laundry
Once the drying cycle is complete, END status led is lighting. If the BUZZER Sig-
nal button has been pressed, an acoustic signal sounds intermittently for about one
minute.
The drying cycles are automatically followed by an anti-crease phase which
lasts around 30 minutes. The drum rotates at intervals during this phase.
This keeps the laundry loose and free of creases. The laundry can be re-
moved at any time during the anti-crease phase. (The laundry should be
taken out towards the end of the anti-crease phase at the latest to prevent
creases from forming.)
1. Open door.
2. Before removing the laundry, remove fluff from the micro-fine filter. It is best to
use a damp hand for this purpose. (See “Care and cleaning” chapter.)
3. Remove laundry.
4. Turn the programme selector to OFF Aus.
After each drying cycle:
- Clean the micro-fine filter and fine filter
- Drain the condensed water container
(See chapter “Care and cleaning”.)
5. Close the door.
daily use electrolux 17