Filter
Top Products
If required, pour fabric softener into the
compartment marked
(the amount used
must not exceed the «MAX» mark in the
drawer). Close the drawer gently.
SELECT THE REQUIRED PROGRAMME
BY TURNING THE PROGRAMME
SELECTOR DIAL (1)
Turn the programme selector dial to the re-
quired programme. The washing machine
will propose a temperature and automati-
cally select the maximum spin value provi-
ded for the programme you have chosen.
You can change these values by operating
the corresponding buttons. The green pilot
light of the button 8 starts to flash.
The selector dial can be turned either clock-
wise or counterclockwise. Turn to position
to reset programme/Switching the ma-
chine off.
At the end of the programme the selec-
tor dial must be turned to position
,
to switch the machine off.
Caution! If you turn the programme
selector dial to another programme
when the machine is working, the red
pilot light of button 8 will blink 3 times
and the message Err is displayed to
indicate a wrong selection. The
machine will not perform the new
selected programme.
SELECT THE TEMPERATURE BY
PRESSING BUTTON 3
By selecting a programme, the appliance
proposes automatically a default tempera-
ture.
Press this button repeatedly to increase or
decrease the temperature, if you want your
laundry to be washed at a different temper-
ature.
REDUCE THE SPIN SPEED BY
PRESSING BUTTON 4
By selecting a programme, the appliance
proposes automatically the maximum spin
speed provided for that programme.
Press button 4 repeatedly to change the
spin speed, if you want your laundry to be
spun at a different speed.
SELECT AN ADDITIONAL RINSE
This appliance is designed for saving water.
However, for people with a very delicate
skin (allergic to detergents) it may be nec-
essary to rinse the laundry using an extra
quantity of water (Extra Rinse).
To activate this option press simultaneous-
ly the buttons 5 and 7 for some seconds.
The relevant icon will appear on the display.
This function stays permanently on.
To remove it press the same buttons again
until the Extra Rinse icon disappears.
SELECT THE DELAY START BY
PRESSING BUTTON 7
Press the button 7 repeatedly to select the
desired delay. The corresponding icon 2.10
will appear on the display.
The set delay time value (up to 20 hours)
will appear for a few seconds, then the du-
ration of the programme will appear again.
You must select this option after you have
set the programme and before you press
button 8.
You can cancel or modify the delay time at
any moment, before you press button 8.
Selecting the delayed star:
1. select the programme and the required
options.
2. set the delay start by pressing the but-
ton 7.
3. press button 8. The machine starts its
hourly countdown. The programme will
start after the selected delay has ex-
pired.
Cancelling the delayed start after hav-
ing pressed button 8:
1. set the washing machine to PAUSE by
pressing button 8.
2.
press button 7 once until the symbol
’ is displayed
electrolux 9